Reply to thread

Hi everyone,


I am currently looking to building a ROTJ Boba Fett helmet. However; I am running into problems with printing the WOF's templates. When I print the templates out using "Fit to paper" the templates are way too small. When I try and scale up the templates and print them I wind up losing parts of the drawings that are on the edges. Has anyone else had this problem? If so how did you fix it? Am I simply missing a step somewhere?


To clarify I am printing on 8.5 x 11" paper using the WOF's templates found here. I am opening the BobA_Fett_Helmet_Template_STD.pdf in Adobe Acrobat and printing from within Adobe. Finally I am using a Brother DCP-7065DN printer.


Thank you in advance!


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top