Reply to thread

Message

I'm building my first ESB helmet, and I have a couple questions:

1) what's the best way to create the dent? The fiberglass bucket I have had an indention, but it was almost completely formless so I bondoed it in. Now I need to make a new one, and I'm just hoping someone has some tips to save time versus needle files.

2) Anybody ever used waterslide decals for the kill stripes? I was thinking of printing mine out, because i did a test with tk409's templates and couldn't get the edges crisp.

[QUOTE="jakob2121, post: 35657, member: 338"] I'm building my first ESB helmet, and I have a couple questions: 1) what's the best way to create the dent? The fiberglass bucket I have had an indention, but it was almost completely formless so I bondoed it in. Now I need to make a new one, and I'm just hoping someone has some tips to save time versus needle files. 2) Anybody ever used waterslide decals for the kill stripes? I was thinking of printing mine out, because i did a test with tk409's templates and couldn't get the edges crisp. [/QUOTE]

This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification