Reply to thread

Message

Hi Fett X,
Depends what your gauntlets are made from. My set is vac' formed styrene, and to secure the 'outside' seams, I used super glue reinforced with 2 small screws/nuts (for each gaunt). For the 'inside' seams, I used the industrial strength velcro. As long as the surface is clean, and you let it set-up per the instructions, the velcro works really well.
Eric

[QUOTE="superjedi, post: 73398, member: 303"] Hi Fett X, Depends what your gauntlets are made from. My set is vac' formed styrene, and to secure the 'outside' seams, I used super glue reinforced with 2 small screws/nuts (for each gaunt). For the 'inside' seams, I used the industrial strength velcro. As long as the surface is clean, and you let it set-up per the instructions, the velcro works really well. Eric [/QUOTE]

This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification