Reply to thread

Thank you, I built my first 3D printer 6 years ago... and I've been hooked on it as a tool for prop making ever since. It's not for everyone, but I love printing. The Mando helmet in my avatar photo was printed and finished by me :). If you know how to work with this tech, know how to prep/finish the parts, and have patience, you can achieve some amazing results.


-Dana


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top