Reply to thread

Message

Thanks! Here's more [USER=4963]RafalFett[/USER] noticed I printed the ROTJ version of this part (whoops!) so I broke out my coping saw and took a few passes at the box-shaped protrusion that needed removal. After that was hacked off, I hit the area with some 120 grit sandpaper:

[ATTACH=full]204564[/ATTACH]

Then I broke out the 3M spot putty (my favorite) and started frosting the cake:

[ATTACH=full]204565[/ATTACH]

We'll see if I need to add any more filler after I sand this down, but for now we wait...

-Dana

[QUOTE="QuartZ, post: 508149, member: 13887"] Thanks! Here's more :) [USER=4963]RafalFett[/USER] noticed I printed the ROTJ version of this part (whoops!) so I broke out my coping saw and took a few passes at the box-shaped protrusion that needed removal. After that was hacked off, I hit the area with some 120 grit sandpaper: [ATTACH=full]204564[/ATTACH] Then I broke out the 3M spot putty (my favorite) and started frosting the cake: [ATTACH=full]204565[/ATTACH] We'll see if I need to add any more filler after I sand this down, but for now we wait... -Dana [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification