Reply to thread

Resin on carboard is OK for shiny things but not for dull paints like the jetpack...


I recommend mod Podge as that was the best solution for me. Put on about 3 good layers of it and them sand it down with high grit  sandpaper. Then just scrub it with a red/gray scotchbrite pad from the dollar store...


Hope that helps:)


Sent from my KYOCERA-E6560


This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top