Reply to thread

Yep, ive made countless molds off my pieces using liquid latex. Just make sure when u paint it on you let each layer dry completely  before doing the next layer. Also when you are about 3 or 4 layers deep, i would lay down strips of "cheese cloth", it helps give the latex strength and will protect it from tearing when you remove it from your piece.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top