Reply to thread

Message

Recently I built the basic N7 helmet from Mass Effect 2 in pep. the initial build for some reason turned out crooked even though i tightly bent all the fold lines, in the right direction, with super glue, and taking all precautions in between.

Has anyone else encountered this problem when building a symetrical object in pepakura? could this be from it being left sitting a certain way inbetween sessions of building it such as right side up on the non reinforced neck causing warping?

I tried to realign the warped spots and it only made other areas worse....I have a feeling that this isn't going to be easy to combat. Any suggestions? pics incoming

[QUOTE="SuperTrooper, post: 290487, member: 3861"] Recently I built the basic N7 helmet from Mass Effect 2 in pep. the initial build for some reason turned out crooked even though i tightly bent all the fold lines, in the right direction, with super glue, and taking all precautions in between. Has anyone else encountered this problem when building a symetrical object in pepakura? could this be from it being left sitting a certain way inbetween sessions of building it such as right side up on the non reinforced neck causing warping? I tried to realign the warped spots and it only made other areas worse....I have a feeling that this isn't going to be easy to combat. Any suggestions? pics incoming [/QUOTE]

This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification