Reply to thread

Honestly, it's probably just more of the same process you are doing.  I think I might've done the UV resin then sandable primer then sanding a few times but not 100% sure.  I think the process you are using will get it done, but will take more iterations.


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top