Reply to thread

I'm new to prop making,but I want to make a BF helmet. I want to make it from fiberglass,but I am unsure quite how to go about it. Is it plausible to make a cardboard helmet and then cover it in fiberglass? Or use the cardboard one to make a mold and go that route? Any feedback or tips are welcome.


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top