Reply to thread

I have found that a band saw is the best thing for cutting plexiglass and sintra.  The jigsaw and scrollsaw, for some reason, don't work as well.  The cut's not as smooth, the plastic has more a tendency to catch and "flap", and you have more of a melting problem since the cut's not quite as wide.


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top