Reply to thread

Just another suggestion, if the plexiglass doesn't have a protective sheet covering one or both sides, you could use masking tape over the areas you will cut (put it on both and bottom).  This usually prevents cracking, you may still have some chipping though, but very minimal.


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top