Reply to thread

Message

I'm starting a conversion in early 2012 for one of these helmets, I noticed from another thread that Evo had started a conversion of a Phase 2 Clone helmet, which looked promising but seems to have stalled. Not sure starting from that point is quite right though. Looks more like a backwards conversion from a TK Lid would be a better starting point (seeing as most of the details stem from that design, including the sweep angle of the cheeks etc). The only Phase 2 element seems to be the Breath filter/vocoder area. Will need to do some fairly large adjustment to the width of the helmet though, as the Phase 3 seems to be thinner than a TK (edging towards the Phase 2 width). A true hybrid!!

[QUOTE="W1ckerMan, post: 284154, member: 5685"] I'm starting a conversion in early 2012 for one of these helmets, I noticed from another thread that Evo had started a conversion of a Phase 2 Clone helmet, which looked promising but seems to have stalled. Not sure starting from that point is quite right though. Looks more like a backwards conversion from a TK Lid would be a better starting point (seeing as most of the details stem from that design, including the sweep angle of the cheeks etc). The only Phase 2 element seems to be the Breath filter/vocoder area. Will need to do some fairly large adjustment to the width of the helmet though, as the Phase 3 seems to be thinner than a TK (edging towards the Phase 2 width). A true hybrid!! [/QUOTE]

This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification