Reply to thread

IMO, the brow line seems like a likely place to start.  It is an oblong disk like this:




the dimesions for the PI are 8.5X10 (inches)

and PII are 8.75X9.5



From there, you can size the dome and other components


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top