Reply to thread

All the way round should be about this thin , being a resin helmet they tend to be thicker so dont need to make it this thin but take it back some what[ATTACH]29505[/ATTACH]

and use some needle files to clean up the back slots


This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top