Reply to thread

Message

Hey again, i've decided to redo my helmet to insure top-class finish. Following this, i've sliced open the cheek area as the helmet cheek area is too shallow.
[ATTACH=full]108801[/ATTACH]

Then i've sanded it and reconstructed it using bits of plastic to make a deep cheek area, which makes the helmet look more complex.
[ATTACH=full]108802[/ATTACH]

PLUS,I've done the dome, yes,its nice and smooth,taking acount of everyones advice.Thks again.

[QUOTE="Trooper937, post: 255932, member: 3792"] Hey again, i've decided to redo my helmet to insure top-class finish. Following this, i've sliced open the cheek area as the helmet cheek area is too shallow. [ATTACH=full]108801[/ATTACH] Then i've sanded it and reconstructed it using bits of plastic to make a deep cheek area, which makes the helmet look more complex. [ATTACH=full]108802[/ATTACH] PLUS,I've done the dome, yes,its nice and smooth,taking acount of everyones advice.Thks again. [/QUOTE]

This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification