Reply to thread

Message

You don't have a Michaels near you? Rubb and Buff Should be in any major and even some minor craft stores. I used it on my helmet and I wouldn't go any other way, it dried up fine for me without a clear coat just look for the threads here about how to apply it a little bit goes a loooooooong way very thin layer to achieve the effect.

Whenever I handle my *ahem* no coments helmet I don't have any problems with the rub and buff coming off. Plus you get a cool silver surfer hand with blisters!!!

[QUOTE="porkins, post: 3128, member: 127"] You don't have a Michaels near you? Rubb and Buff Should be in any major and even some minor craft stores. I used it on my helmet and I wouldn't go any other way, it dried up fine for me without a clear coat just look for the threads here about how to apply it a little bit goes a loooooooong way very thin layer to achieve the effect. Whenever I handle my *ahem* no coments helmet I don't have any problems with the rub and buff coming off. Plus you get a cool silver surfer hand with blisters!!! [/QUOTE]

This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification