Reply to thread

It seems like every time I try to add a second coat to anything, the surface seems to acquire a kind of bumpy texture to it. This is even more obvious when using Rustoleum Metallic Finish as it is reflective, and thus the bumps can be seen easier. Has anyone else experienced this? Is there any way to avoid it?


Any info is greatly appreciated!


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top