Reply to thread

I'm new to this forum and I'm really excited about the progress I have made on my armor so far. I'll give you guys a little bit of a back-story. My armor is made from a trash can, and I am using the satin finish paint. So far, I have painted the green on, but NOW its time for the yellow.

 

Everytime I do the yellow though, it either cracks the green, runs, or does many other crazy things. Is there a specific kind of paint that I need, is my technique off, or is that just normal? I'm really sorry if this is a ridiculous question, but its hard for me to progress if I can't get that yellow on.

 

 Thanks!:)


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top