Reply to thread

I always liked these so I want to build one. I joined the forum for them but figured I'd ask here if anyone built one. I got an ABS helmet that will need to be chromed. It is split in 2 halves. The originals have an unfinished seam line covered by silver tape. Would you build it that way or fill the seam? Bit bummed cause I thought I knew someone who did Spectra chrome but he got out of it since the chrome would yellow and they weren't supporting his issues. Now I have to figure out where to get it chromed. May try and use high end vinyl wrap.


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top