Reply to thread

Message

Two reasons

1) RS Components was the go-to source for a lot, if not most, of Fett's electronics, which were completed in England. Alco is American.
2) Someone I trust has verified for me the RS 339-241 is indeed the correct part.

Hopefully those with evidence will share when they can someday. Otherwise, I see no problem using Alco if that's what you have. Which is what I was curious to find out.

[QUOTE="Ord Mantell, post: 531228, member: 12897"] Two reasons 1) RS Components was the go-to source for a lot, if not most, of Fett's electronics, which were completed in England. Alco is American. 2) Someone I trust has verified for me the RS 339-241 is indeed the correct part. Hopefully those with evidence will share when they can someday. Otherwise, I see no problem using Alco if that's what you have. Which is what I was curious to find out. [/QUOTE]

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification