Reply to thread

Message

Hi
I would try to get the chamfering done without a dremel first. Being a power tool, making a mistake that causes you to throw away the borden only is all too easy. Just get a drill thats the correct sitze (slightly larger then the holes) and turn it by hand. As if to de-burr a drilled hole. See how far that will get you. It being aluminum?, it shouldnt be too much trouble.

[QUOTE="RamSkirata, post: 498286, member: 14052"] Hi :) I would try to get the chamfering done without a dremel first. Being a power tool, making a mistake that causes you to throw away the borden only is all too easy. Just get a drill thats the correct sitze (slightly larger then the holes) and turn it by hand. As if to de-burr a drilled hole. See how far that will get you. It being aluminum?, it shouldnt be too much trouble. [/QUOTE]

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification