Reply to thread

Message

I purchased a set of armor plates off ebay that are pristine (no battle damage) I've read that dremmeling sintra is bad for it, but to rather heat it like you would be shaping it to add the dents.

I'm wondering if any of you awesome prop builders have any suggestions as to what is the best thing to use for this. I was thinking about getting various sizes of ball bearings or marbles, I'm also thinking maybe RPG dice. With the dice I'm afraid that the sintra might stick or melt the die. Ball bearings I think might give too perfect of a dent (ie too symetrical).

Any thoughts on this?

[QUOTE="lordfett, post: 42537, member: 352"] I purchased a set of armor plates off ebay that are pristine (no battle damage) I've read that dremmeling sintra is bad for it, but to rather heat it like you would be shaping it to add the dents. I'm wondering if any of you awesome prop builders have any suggestions as to what is the best thing to use for this. I was thinking about getting various sizes of ball bearings or marbles, I'm also thinking maybe RPG dice. With the dice I'm afraid that the sintra might stick or melt the die. Ball bearings I think might give too perfect of a dent (ie too symetrical). Any thoughts on this? [/QUOTE]

This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification