Reply to thread

I guess we aren't the only ones then. :D

Yeah, we used an exacto knife, and followed pretty much the same steps Rammage followed.

Also, we don't have a dremel so we just cut it with the x-acto. Didn't turn out too bad. Plus as Rammage said, not much cleanup. :D


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top