Reply to thread

6mm?  Egads!  That's GOT to be difficult to bend!  I guess boiling it would work.  The thickest that I use is 3mm, and even with a 1000 Watt heat gun it takes some time.  I thought about making gauntlets out of 2mm Sintra since it's so easy to work with, but I'm not crazy enough to use anything as thick as 6mm!  ;)


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top