Reply to thread

when doing a jango helmet, i start off with 120 grit on a mouse sander, then 220 with the mouse as well. after that i go to hand sanding, 400-800-1000. i skip the 0000 steel wool, and instead use metal polish to get a great shiny finish on it.


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top