Reply to thread

Hey folks.  Yes, I'm a noob, as my bucket will no doubt reveal. Here it is, minus the ear decals.  -working on that.


This was made from one of the cheap ass rubber models.  I don't even remember the manufacturer, I bought it a few years ago and did nothing with it until now.







The only problem I found I couldn't fix was doming the top of the helmet which was quite flat when I bought it.  I did improve it some after hours of tedious hours warping it with a heat gun.  By the time I bondoed the inside of it though, it had begun to flatten out again.  Hope its not TOO noticable.


Let me know what you think.

Cheers!


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top