Reply to thread

Message: <blockquote data-quote="Ghostfacethrila" data-source="post: 484294" data-attributes="member: 12410">i actually spoke to Cruzer back in April and he said he would be making a new mold to cast some for a few clients “this summer”, and then he would pass on the new ones the Kevin Weir to continue to produce. Ive been in contact with KW recently but he still doesnt have them and it doesnt look like Cruzer has made a new one yet either.Sadly there are no 3d prints for this pack specifically, only paper pepakura files. My only hope is that someone has one that they arent going to use but i know it’s unlikely. Thought i’d take a chance here.</blockquote>

This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification