Reply to thread

Cruzer no longer produces them. He sold his mold to Kevin Weir at Imperial Surplus....unfortunately KW hasn't modified the mold for rotocasting yet. If you follow KW on instagram he has mentioned a few times that it is on his list to do but hasn't gotten around to it.  Are there 3D print files out there for the pack? That could be an option.


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top