Reply to thread

Hey all I have started down my Jango Journey. I am a GIANT Boba fan, but figured I needed to officially start with the father, before the son. So, I have already received some 3D printed Blaster pistols which came out awesome. Just need to assemble and paint. I will probably be going cold cast bucket. I was wondering if anyone has an opinion on the ABS armor/parts? anyone currently have them and like them, don't like them? what does it look like? and what paints did you use? I might take a crack at making my own jumpsuit and belts. may out source my holsters, and flak vest. come on guys and gals, give me some help here and let me know where I'm going! thanks.


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top