Reply to thread

I used a bicycle helmet for the dome area and used WOF's Templates to build face/side area.  I cut the sides of the bicycle helmet w/ a dremel then sanded it down to where it was straight across.  I was going to use one of my old hockey helmets to make another scratch helmet using the same idea.


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top