Reply to thread

Penpen, sorry it took me so long to get back to your question but my day job keeps me very busy.


To answer you my template has a 1 inch bar on the top center of it that should exactly 1 inch after printing. so check that to adjust your size a little better. also the template is made to be used for the sintra and then to be bondo-ed and sanded after the fact so there is a little le-way built in to it. that is just how i designed it originally.


Again sorry for the delay. I've been working 16 hour days my job as a veterinarian keeps me pretty busy.

Kakarrot


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top