Reply to thread

OK guys here is the template for the faceplate I made, wile molding mine. You should be able to print it out easy enough, and using the inch marker on the center top. it should be easy to check that the final size is correct.


Its still may need a trim hear and there, If you look at the photo of mine with the sintra mounted you will note i cut the lower half of the face off and mounted them apart from the rest, mostly to make it easier for me to get things lined up right.


Please let me know if you all have questions, I will be posting more pics when time allows, but with my work I only sleep 2-4 hours a day so trust me when I say you will have to bear with me if i'm a tad slow on the updates.


Kakarrot (epicfett@twitter.com)[ATTACH]24173[/ATTACH]


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top