Reply to thread

Alright, here is another tutorial (I guess it's a branch off of the helmet one):


Bondoing 101 :D


Alright, start with these:

  Bondo

  Hardener

  Applying tool (refered to as the BAT; Bondo Applicator Tool)

[ATTACH=full]107903[/ATTACH]

[ATTACH=full]107904[/ATTACH]

[ATTACH=full]107905[/ATTACH]


Then, you take a small-ish amount of bondo (I use about a golfball sized amount)

[ATTACH=full]107906[/ATTACH]


Add the required amount of hardener (read the bondo can label...I never use the right amount so I dont know what it is...:D)

[ATTACH=full]107907[/ATTACH]


Stir THOROUGHLY...

[ATTACH=full]107908[/ATTACH]


Then, using the BAT, apply the bondo to your construction in a spreading motion, leaving a thin, mostly even coat:

[ATTACH=full]107909[/ATTACH]

[ATTACH=full]107910[/ATTACH]


And then your done!!! :D repeat process until you get a nice, even coat over the entire helmet. Hope this helps guys!


:cheers

A'den


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top