Reply to thread

Like the topic says....  Exactly where do the square/rectangular holes go for the JP straps???  I guess a measurement from the bottom of the plate would be best as that is where there is a straight surface as opposed to the rounded shoulder part..


thanks for the help all

dan


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top