Reply to thread

Message

Did a little work today. I opened and cleaned the eye slit and will be working on the width of the vertical opening. I cleaned up the welds some where the dome was welded to the face wrap shaping the upper ridge.
[ATTACH=full]247995[/ATTACH][ATTACH=full]247996[/ATTACH][ATTACH=full]247997[/ATTACH]

[QUOTE="Slave1Pirate117, post: 537798, member: 15246"] Did a little work today. I opened and cleaned the eye slit and will be working on the width of the vertical opening. I cleaned up the welds some where the dome was welded to the face wrap shaping the upper ridge. [ATTACH type="full"]247995[/ATTACH][ATTACH type="full"]247996[/ATTACH][ATTACH type="full"]247997[/ATTACH] [/QUOTE]

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification