Reply to thread

actually i just used a block of pressure treated 2X4 i had laying around...and a lot of sanding with the sanding attachment for the dremel...


cut the two holes needed with a hole saw first, then cut out the block shape around the holes with a box cut saw(yes by hand, no ban saw here:lol: ) then i just worked it with the dremel sander....oh and about 20 heavy coats of paint, flat black rustolium...a wet sand and a couple more coats


nothing too tough...they look pretty good...not perfect but they definatley do the job


thanks BTW for the complement....


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top