Reply to thread

Message

Looks fabulous, DCB. I too, make "working" triggers on my pieces. I would only counsel that you either incorporate a slide stop that could be concealed within the receiver, or at least utilize the trigger guard to keep from having the trigger wobble or pop out. The screw that guides through the slot and grip will only provide one point of contact out of two necessary at the length that the hole appears to be. If the slot and corresponding slot in the grip were two or three times longer/deeper then there would be no problem. I hate not being able to whip out an old envelope or bar-napkin and sketch this stuff out. Sorry if I'm not too clear.

[QUOTE="Megalomaniac Mando, post: 12773, member: 199"] Looks fabulous, DCB. I too, make "working" triggers on my pieces. I would only counsel that you either incorporate a slide stop that could be concealed within the receiver, or at least utilize the trigger guard to keep from having the trigger wobble or pop out. The screw that guides through the slot and grip will only provide one point of contact out of two necessary at the length that the hole appears to be. If the slot and corresponding slot in the grip were two or three times longer/deeper then there would be no problem. I hate not being able to whip out an old envelope or bar-napkin and sketch this stuff out. Sorry if I'm not too clear. [/QUOTE]

This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification