Reply to thread

I finished (most of the) handle this weekend...



Ugh - what a pain.. it's all made from hand cut styrene. All i have to work with is an exacto knife, a small worktable, lots of sheets of styrene, putty & sandpaper. It's a pain - but that's how I made all the pieces so far (gauntlets, broach, etc.)


I placed Kimncris' blaster handle next to mine for a size comparison. From my measurements - i get a much bigger gun than they did. That's OK though. I think i remember Cris saying that they scaled down their gun for some reason.


I also made the disk that goes in the "eye" looking detail on the side - but it's not pictured.


The trigger (sitting next to the handle) will be spring loaded - so it will actually work (well, it will move, at least) :D


I just need to make the long flat piece that the barrel rest on - but i may wait until i get the barrels back from the machinist. And find (or make) the greeblies that go on the front and back of the box that's right above the handle.


more soon....


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top