Reply to thread

Thanks very much Count'. ;)


Ok, the helmet is now in the hands of Mojo-Fett. He got it yesterday ready for moulding the lid. Also, he very kindly turned an aerator for this lid on a lathe! :) The aerator isn't the same as a TK or the clones we see in EpIII. The idea is to use this one master part to mould and cast resin copies to include with the kit.


[ATTACH=full]108053[/ATTACH]

[ATTACH=full]108054[/ATTACH]


Hope it looks good to you guys, I think he nailed it myself. Thanks Gav!! ;)


This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top