Reply to thread

It's been a while since I posted an update. The lid is now finished!


I'll be sending it to my buddy, Mojo-Fett for moulding and casting either today or Monday. So before I start an interest thread, I wanted to get some feedback on what people would like? The way I see it you can either have a simple raw cast lid and the resin greebles(mouth inserts and aerators), or the addition of precut vinyl cowl with the lid?


Obviously having the cowl supplied would effect the final price but I just want to see what people would prefer so I can look into the cost of the vinyal material.


Also, remember, we're in the UK so shipping for our US friends will be extra.


Any and all feedback concerning this would be much appreciated!! ;)


This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top