Reply to thread

I couldn't find where this has been done already but Ive been getting ready to repaint my ROTJ pack. I decided to start building stencils in vector for the really nasty, complicated parts based off of C4 Photos. In this case the piece running down the middle of the pack, below the rocket.


Just wanted to post to see if anyone wanted me to share these as I build them.

I have spent many hours painstakingly re-drawing each detail the best I can, and while I'm not claiming it's 100% accurate, I still think I captured the detail well and I'll be using it on my own pack.


My scale is setup for my MLC pack so it may not match other sculpts perfectly. However it is built in Illustrator CS3 so there is room to scale the art a little.


If there is any interest in posting the .ai file, I will do so.


Comments are welcome.


Thanks!


[ATTACH=full]106105[/ATTACH]


This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top