Reply to thread

Hi all, I managed to pull apart my EE3 from Sidewinder to try and get it accurate as possible for my skill level.


I used Vallejo acrylics, water, my finger and a micro fibre cloth.


Oh and some 0000 steel wool.


Have to say I am very pleased with the results and I hope you like it too.


My phone tends to make grey look like blue and yes I’m missing a small part as it broke unfortunately but easily replaced.[ATTACH=full]244121[/ATTACH]


This thread is more than 8 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top