Reply to thread

My rubber blaster made by Cruzer.

I did a little sand on them filled out some little holes with special k glue, this glue is very strong but i add a screw to secure just in case, then a cover the top screw with the same glue.


[ATTACH=full]13349[/ATTACH]


[ATTACH=full]13350[/ATTACH]


[ATTACH=full]13351[/ATTACH]


[ATTACH=full]13352[/ATTACH]


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top