Reply to thread

Per Request...

Here is the way I installed the removable MQ-1 circuit board...

 

Used the same method on this as the Visor ....using a TEE NUT...as shown in POST #27

 

hope this helps..;)


[ATTACH=full]5455[/ATTACH]


[ATTACH=full]5456[/ATTACH]


[ATTACH=full]5457[/ATTACH]


[ATTACH=full]5458[/ATTACH]


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top