Reply to thread

I was able to get most of the assembly completed.  I'd say I'm about 95% done with this, just have a few finishing touches.


I've got less than $85 in this, pretty happy with it.


[ATTACH=full]140028[/ATTACH]


[ATTACH=full]140029[/ATTACH]


[ATTACH=full]140030[/ATTACH]


[ATTACH=full]140031[/ATTACH]


[ATTACH=full]140032[/ATTACH]


[ATTACH=full]140033[/ATTACH]


[ATTACH=full]140034[/ATTACH]


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top