Reply to thread

Not a whole lot of time to work on this, but its coming along.  Finished up the box and rough cut the holes for the panels.  I still have the holes to do at the base and the top, then I want to seal this and get working on the front panel. 


I also rounded the outside edges and will do the same to the inner edges around the front panel.







This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top