Reply to thread

Thanks guys, I appreciate the feedback. Let me know of any suggestions.

I'll notch out the recessed areas for the exposed hinge once I receive some very accurate hinge that's coming all the way from Italy.

I'll also start fabricating the right gauntlet top hose attachment and hose fittings, and flamethrower nozzles.

I edited the thread with some better pics.:thumbsup:

 

thanks


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top