Reply to thread

thanks for the replies ,guys


update i joined the front and back together. i raised the brow up to meet the viser. started on the triangle on the chin. got the place where the viser and helmet meet to go together better. started cutting out the vents to make the wall of the helmet go into the vent like in the screen shots. not just stop where the vent starts.  i have also started the greeblies for the breathers but the little filter is under and inch of rtv rubber right now or i would show you. some of the lines are just penciled in.

[ATTACH=full]101415[/ATTACH]

[ATTACH=full]101416[/ATTACH]

[ATTACH=full]101417[/ATTACH]

[ATTACH=full]101418[/ATTACH]


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top