Reply to thread

Message

It's getting there......!
Just got to finish some of the weathering, and mist it all off so that its not so shiny and clean, then install the hollow RF and LEDs and I think its about ready!

I've been working on this for ages and I'm really proud of it, it looks so much better than my first attempt. PLease let me know any of your comments.

The flash ahs made it look a lot lighter than it really is though

[ATTACH=full]411[/ATTACH]

[ATTACH=full]412[/ATTACH]

[QUOTE="mandalore697, post: 46197, member: 594"] It's getting there......! Just got to finish some of the weathering, and mist it all off so that its not so shiny and clean, then install the hollow RF and LEDs and I think its about ready! I've been working on this for ages and I'm really proud of it, it looks so much better than my first attempt. PLease let me know any of your comments. The flash ahs made it look a lot lighter than it really is though [ATTACH=full]411[/ATTACH] [ATTACH=full]412[/ATTACH] [/QUOTE]

This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification